Urban planning community

+ Reply to thread
Results 1 to 2 of 2

Thread: Wall heights

  1. #1
    Cyburbian
    Registered
    Jan 2005
    Location
    Carlsbad, CA
    Posts
    81

    Wall heights

    The city I work for is currently looking to revise the wall height standards in our downtown area. In particular, properties where a commercial use is adjacent to a residential use. For example, most cities in the area we have surveyed allow the wall height to be increased to up to 8 ft if commercial is lcoated next to residential. But what I want to know now after finding that 8 ft is the most common allowance, is where do you measure the wall height from. Especially in cases where one property has a higher grade or plans to fill anywhere from 2-4 ft of dirt. Do you measure from the higher or lower grade? Because if you measure from the higher grade, the commercial site (say if this was the higher grade property) would have an 8 ft wall and the residential property would be looking at a 10-12 ft wall depending on how much higher the comemrcial site is. But if you measure from the lower residential side, the residenital would have an 8 ft wall but then the commercial site could have a wall of 4 ft-6 ft leading to privacy issues.

  2. #2
    We use the average of the adjacent grades at the proposed wall/fence location unless there is an hard, durable surface (driveway or sidewalk) on one of the sides, in which case that elevation prevails.
    On pitching to Stan Musial:
    "Once he timed your fastball, your infielders were in jeopardy."
    Warren Spahn

+ Reply to thread

More at Cyburbia

  1. Occupy Wall Street
    Friday Afternoon Club
    Replies: 209
    Last post: 16 Jul 2012, 4:20 PM
  2. Replies: 30
    Last post: 13 Oct 2011, 4:19 PM
  3. Tempe, AZ will go wall-to-wall wireless
    Economic and Community Development
    Replies: 15
    Last post: 23 Jun 2006, 10:21 PM
  4. Replies: 0
    Last post: 19 Jan 2005, 9:51 AM